Maintenance/Cleaning
5 Maintenance/Cleaning
5.1 Maintenance
Warning!
Risk of injury.
Disconnect the power supply before starting maintenance, repair and cleaning work.
Warning!
Heavy component weight
This can cause injuries.
If necessary, remove with assistance.
Warning!
This can cause injuries.
Always wear goggles, dust mask and gloves when using compressed air for cleaning
purposes.
Comply with the regulations of the spreading material manufacturer.
After use, empty the material hopper and clean vehicle with brush or compressed air.
Dosing device/slide
The dosing device and slide should be inspected and cleaned at regular intervals depending on use and the
spreading material used.
If using very fine spreading material in particular, the slide unit may clog.
1. Disconnect agitator plug.
2. Unscrew upper and lower knurled screws
(1)
on both sides.
3. Remove the hopper
2
.
4. Unscrew the four nuts
(3)
using a 17 mm spanner.
5. Remove hopper platform
4
and pull the dosage slider
5
out from the top.
6. Clean the slide unit with a brush or compressed air.
7. Fit parts in reverse order.
Standard lubricant can be applied to the bottom edge to assist with hopper installation.
Drive motor
The drive motor of the spreading disc should be cleaned and greased at the end of the season. This extends the
service life of the motor. Carry out the maintenance work correctly, otherwise the manufacturer's warranty may be
invalidated.
POLARO
®
1.1
15 / 34
Summary of Contents for POLARO
