Minimum required distances:
a)
50cm from the side wall
b)
At least 50cm from the ceiling
Assembling Process
Step 1: Fix the Heater Pole on the base by using the provided 3PCS of M4 *14mm
screws.
Step 2:To fixed the base by pull blasting screw and base retainer plate:
OPERATING INSTRUCTIONS
WANRING: The heater must be properly installed before it is used This unit is equipped
with one heat setting
On I Off.
Plug the Patio Heater into a grounded 220-240V 50-60Hz power outlet.
Press on the On/Off switch to the "I" position to activate the heater.
Touch switch
Touch on the panel
once:
Switch on for 1000W of the upper heating element.
Touch on the panel
twice:
Switch on for 1000W of the lower heating element.
Touch on the panel
three times
: Switch on for 2000W, means both heating elements
are running at the same time.
Touch on the panel
four times
to turn the heater off.
The remote control
Press the upper
bottom, it’s 1000W for the upper heating element;
touch it again to close the heater.
Press the below bottom, it’s 1000W for the heating element below;
touch it again close the heater
Press the above bottom and below bottom at same time, the heater will be 2000W.
