BD
A Primar
y Con
tr
oller / Sec
ondar
y Con
tr
oller 22-02-17 (GB)
4
CARE & MAINTENANCE
U
Do not spill any liquid over or into the individual components of the lock, incl. primary controller and secondary
controller
U
Only clean the components of the locking system including the primary controller and secondary controller with a
clean, soft and slightly damp cloth.
U
Do not use any cleaning agents containing abrasives or solvents, as these may damage the housing.
U
Treating any of the electronic and mechanical components improperly or in a any way other than described in these
operating instructions may lead to malfunctions and the loss of warranty.
U
Replace defective components immediately or take them out of operation.
INTENDED USE
The primary and secondary controllers described in these instructions may only be used with components of the
LEHMANN Captos system. Only by using LEHMANN Captos components it is ensured that the quality requirements
are met and reliable operation is possible. The use of third-party components, such as cables, cannot guarantee
reliable operation. Permitted system components are specified below:
Name
Function
Captos
Furniture / locker lock
Captos iCharge
Furniture / locker lock, Additionally with USB charging function for smartphones and tablets
(USB-A) and RGB backlighting
Primary Controller
• Power supply to the locks
• Communication between locks and Lehmann Management Software LMS
(Transfer point to the customer‘s LAN)
• Communication between secondary controller and LMS
Secondary Controller
• Power supply to the locks
• Communication between locks and primary controller
Power supply
Power supply of a primary or secondary controller. When using Captos locks, one power supply
unit can supply up to three controllers with power. When using Captos iCharge locks one power
supply unit per controller is required.
Power cord
Connection between power supply unit and country-specific socket
Power connection cable
For power supply between a controller and a downstream controller instead of a power
supply unit when using Captos locks (not possible with Captos iCharge locks!).
Connection cable
• 4-pole cable with RJ12 plugs
• Energy and data connection between locks and primary or secondary controller
• Data connection between controllers
LEHMANN Management
Software „LMS Online“
Software for the administration and configuration of the Lehmann RFID locks. LMS is ope-
rated in the customer‘s IT infrastructure. LMS Online is a special LMS license for the use of
functions in connection with Captos and Captos iCharge.
Master- and
programming cards
To configure the locks if the LMS is not to be used
User cards
The transponders contain encrypted information and are equipped with individual access
authorizations for the locks and serve as keys for authorized persons.
If transponders from third-party manufacturers are to be used, it is strongly recommended
that LEHMANN carries out a compatibility and range check in advance.
