Note
The photo shows the ceiling box for a CeilingMIC. The EasyIP CeilingMIC D has a larger circuit board.
Preparing the Ceiling
You will need to make a hole in the ceiling. The hole needs to be slightly smaller than the trim plates.
Warning
Follow standard safety practices when using ladders or lifts. Failure to do so can result in injury or death.
We like you, we don't want you to be injured or killed, and we hope you understand the gravity of the
situation.
If installing in a hard ceiling:
Make sure there is room for the ceiling box and its cables at the location where you want to install it.
If installing in a suspended tile ceiling:
1. Remove the ceiling tile where the microphone will be mounted, and make a hole in the tile.
2. Reinstall the ceiling tile and position the tile brace.
Note
Because the microphone assembly weighs very little, the tile brace does not need to be physically
attached to the tile support grid unless this is required by local building codes.
Complete Manual for the EasyIP CeilingMIC/AMP D Network-Connected Amplifier and Overhead Microphone
6
