LEGRAND Raritan SRC-0100, User Manual

Page: 93 / 698

Chapter 5: Introduction to SRC Components
81

To mute the beep sound immediately, press . See
Muting
the Internal Beeper
(on page 81).
3. Press to show the status of the 12V power supply to the
controller. For details on this sensor, see
+12V Power Supply
Sensor (on page 114).
4. To return to the Main Menu, press .
Muting the Internal Beeper
After enabling the internal beeper's mute control function, you can
choose to mute the beeper via the front panel whenever the beeper
sounds for an alarm.
By default, the beeper's mute control feature via front panel is enabled.
Tip: To disable this feature, see
Front Panel Settings
(on page 306).
To mute the internal beeper during an alarm:
1. Press or to select "SRC" in the Main Menu, and press
.
2. Press . A confirmation message appears.
3. Press to select Yes and then press .
4. The beeper stops beeping, and the Beeper State shows "Active
(Muted)".
Note that the alarmed state remains unchanged yet for the moment.
Peripherals
If there are no Raritan environmental sensor packages connected to your
SRC, the LCD display shows the message "
No managed devices" for the
"Peripherals" menu command.
If you have enabled the front panel actuator control function, you can
switch on or off a connected actuator using the LCD display. See
Miscellaneous
(on page 314).
To show environmental sensor or actuator information:
1. Press or to select "Peripherals" in the Main Menu, and
press .
2. The display shows a list of environmental sensors/actuators.