LEGRAND Raritan SRC-0100, User Manual

Page: 596 / 698

584
You can use either the reset button or the command line interface (CLI)
to reset the SRC.
Important: Exercise caution before resetting the SRC to its factory
defaults. This erases existing information and customized settings,
such as user profiles, threshold values, and so on. Only firmware
upgrade history is retained.
Alternative:
Another method to reset it to factory defaults is to use the web interface.
See
Resetting All Settings to Factory Defaults
(on page 340).
In This Chapter
Using the Reset Button ........................................................................... 583
Using the CLI Command ......................................................................... 584
Using the Reset Button
An RS-232 serial connection to a computer is required for using the
reset button.
To reset to factory defaults using the reset button:
1. Connect a computer to the SRC. See Connecting the SRC to a
Computer
(on page 21).
2. Launch a terminal emulation program such as Kermit or PuTTY, and
open a window on the SRC. For information on the serial port
configuration, see Step 2 of
Initial Network Configuration via CLI
(on page 657).
3. Press (and release) the Reset button of the SRC device while
pressing the Esc key of the keyboard several times in rapid
succession. A prompt (=>) should appear after about one second.
4. Type defaults to reset the SRC to its factory defaults.
5. Wait until the reset is complete.
Appendix E Resetting to Factory Defaults