www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United State swith more than 50% of the component cost of US origin It may be covered by patents
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
2
INSTALLATION INSTRUCTIONS
F-4260_091118
1:
Remove tertiary lens (if provided) by unscrewing (4) captive screws.
2:
Remove heatsinking/LED base by unscrewing (4) captive screws.
These will be the inner most screws.
3:
Disconnect the quick connector wires from the LED board and
the driver.
4:
Make electrical connection to J-box (for sizes, see next page). Circuit
wire connection must be in J-box. Install housing to surface using (4)
5/16" diameter mounting holes.
5:
Re-assemble by reversing the removal procedure.
DRIVER
QUICK CONNECT
HEATSINK/LED BASE
CAPTIVE SCREWS (4)
FOR REMOVING HEATSINK
CAPTIVE SCREWS (4)
TERTIARY LENS (IF PROVIDED)
HOUSING
HOUSING TOP VIEW
5/16” MOUNTING HOLES (4)
DIRECT TO SURFACE INSTALLATION
