03
_20
19
LE
06
39
7A
U
E
Warranty
Legrand warrants this product for a period of specific years from the date of
purchase.(Please refer to specification table).These goods come with guarantees
that cannot be excluded under the Australian and New Zealand Consumer Laws.
You are entitled to a replacement or a refund for a major failure and for
compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired if the goods fail to be acceptable quality and the
failure does not amount to a major failure.
See the Warranty card enclosed with this product for further details.
Customer Service
For all Customer Service and Technical Support
please call Monday to Friday during business hours.
Legrand Australia
1300 369 777
www.hpm.com.au
Legrand NewZealand
0800 476 009
www.hpm.co.nz
ABN: 31 000 102 661
Product Notes
9
1. This product must be installed and used as per these instructions.
2. This product should only be cleaned with a damp cloth. Cleaning agents and solvents should not be used.
3. This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
4. Children should be supervised to ensure that they do not play with the appliance.
5. This product is intended for household use and similar purposes. It is not suitable for use in and environment heavily laden with dust. Under these
conditions the life of the fan motor can be significantly reduced.
6. This product should not be enclosed in thermal insulation as it may cause the unit to overheat.
7. This product has been designed to operate in ambient temperatures 0
°
C to 50
°
C.
8. This product contains no serviceable parts and no attempt should be made to repair it. If the product is faulty it should be discarded.
9. If the supply cord is damaged, it must be replaced by Legrand, its service agent or a similarly qualified person in order to avoid a hazard.
10. Airflows listed in this product indicate the product performance. Refer to the BCA (Building Code of Australia), or similar, for the appropriate airflow required
for a particular installation.
11. Ventilation products must have an adequate source of external air to ensure correct performance.
12. Consideration must be taken in the installation of ducts to ensure that condensation that will form in the duct will not run into the fan engine.
13. Precautions must be taken to avoid the back-flow of gases into the room from the open flue of gas or other fuel-burning appliances.
14. This product has been designed for domestic or similar uses and is not suitable for a commercial installation.
15. This product is not suitable for installation in hazardous and/or corrosive areas.
16. Extended exposure to UV rays (such as exposure to direct sunlight) may cause discolouration of this product.
17. The material in this product may vary in colour from batch to batch. Colour matching from one batch to another cannot be guaranteed.
18. This product utilises intellectual property in the form of registered designs, trademarks, and/or patents. Such intellectual property remains the property of
Legrand in allcases.
19. Legrand reserves the right to modify the specification of this product at any time.
Timer function
8
Condition
Timer Module
LS is Powered OFF (Initial)
Fan does not run
LS is Powered ON
Fan runs continuously
LS is Powered OFF
Fan runs for Preset time and Switches OFF
LS is Powered ON and OFF immediately
Timer is Reset and fan runs for Preset time and Switches OFF
Fig. 14
Timer Adjustment
The default setting is to
3 min(approx). Adjust to
desired time delay.
MINIMUM
(3 minute)
MAXIMUM
(29 minute)
