Page
7
301 Fulling Mill Road, Suite G
©Copyright 2012 by Legrand,
Middletown, PA 17057
Inc All Rights Reserved.
(800)-321-2343
www.onqlegrand.com
1.3 Detailed Physical Description
Router/Switch Module Connection Area
Figure 2
shows the Router/Switch connection area including:
DC Input connector – from power supply
WAN (Internet) Port – 8 position RJ-45 jack (to Cable or DSL or FIOS modem)
Local Switch Ports – 8 position RJ-45 jacks (from outlets in rooms)
Routing Switch – Disconnects router from 4-port switch when an external router is used
and converts WAN port to 5
th
switch port (power re-cycle required).
Reset Button -
A button press cycles the power, while a ten (10) second press and hold
resets the Router/Switch unit to the factory default settings. This clears all user settings,
including User Name, Password, IP Address, and Subnet Mask.
NOTE: Refer to
Section IV
Configuration
for instructions on re-configuring the
Router/Switch.
Router/Switch Status LEDs next to each RJ45 connector(see
Figure 2
)
Power
– On solid green when power is supplied.
Link/Act and 1000 Local Port and WAN Port LEDs
Link/Act
– On solid green indicates functional LAN or WAN link through the port with the
attached device. Off means no LAN or WAN connection.
1000
– On solid green indicates port is operating at 1000 Mbps. Off indicates otherwise.
Figure 2
DC Input
Reset
Button
WAN
Port
Local
Switch
Routing
Switch
