XSD1U
Installation Instructions
10
8.
Mark hole locations for lower two mounting holes. (See
Figure 9)
9.
Remove mount (A) from top bracket.
10. Drill two 3/8” holes at marked hole locations. (See Figure 9)
Figure 9
11. Install an anchor (F) into each pilot hole using a hammer,
making sure that the anchor is flush with the wall. (See
Figure 10)
Figure 10
12. Hang wall mount back onto top bracket and install two 5/16
x 2 1/2” hex head cap screws (G) through two 5/16"
washers (H), lower mounting holes on mount and into
concrete anchors. (See Figure 11)
Figure 11
13. Use two 1/4-20 x 1/2" button head cap screws (N) and 1/8"
hex key (R) to secure mount to wall. (See Figure 11)
Installing to Steel Studs
Make sure installation site meets the requirements shown on
page 11 or 12. (See Figure 12) or (See Figure 13)
x
x
8
10
3/8” (9.5mm)
(F) x 2
11
(G) x 2
12
(N) x 2
13
(H) x 2
