TILD1X05US / TILD1X1US / TILD1X2US / TILVAB2
Installation Instructions
8
Installing First Mount
The TILD1X05US / TILD1X1US /TILD1X2US (U-Slim Series)
LED wall mounts are designed to be mounted to a bare 8"
concrete wall or 8"x 8"x 16" concrete block wall
Table 1: Fastener Information
1.
Hold furthest left, top wall mount against wall ensuring that
mounting slot is lined up with center line marked on the wall
in
Determining Installation Site
section. Double-check
with a level. (See Figure 9)
2.
Mark mounting holes in two top mounting slots along the
horizontal line marked in Step 3. (See Figure 9)
NOTE:
The mounting holes are 13.34" apart on-center for left
and center. (See Figure 9)
Figure 9
3.
Drill two pilot holes (see Table 1 for size) at each location
marked in Step 2 (See Figure 9) and follow fastener
information located in Table 1.
IMPORTANT ! :
Refer to
Fastener Installation Methods
(located in
Appendix
at end of Installation Instructions)
for details on installing product into various wall types.
4.
Partially install two lag screws into wall, but do NOT
completely tighten to wall. (See Figure 10)
NOTE:
(OPTIONAL)
If more LED screens need to be added to
the top or bottom of the screen configuration, add
TILVABPT vertical connector kit (not included) to top or
bottom of wall mount following instructions in the
(OPTIONAL) Adding Vertical Connector Kit
. If you
are NOT adding the TILVABPT connector kit, proceed
to
Step 5
.
Figure 10
5.
Hang wall mount, aligning upper mounting slots over
fasteners, and adjust side-to-side for proper location, but do
NOT completely tighten to wall. (See Figure 10)
6.
Place a level across front of the mount at bottom of teardrop
slots. (See Figure 11)
7.
Check the level of the mount at the bottom of the teardrop
slots. (See Figure 11)
Figure 11
WALL
TYPE
PILOT
HOLE
FASTENERS (see PARTS
drawing)
Concrete or
concrete
block
3/8" x 3"
- 5/16 x 2-1/2" flanged hex head
lag (
C
)
- 5/16" washer (
D
)
- Adjustment washer (
A
)
- Fischer Anchor UX10x60R
(B)
2
13.34 inches
3
Line showing
mounting slots
for mounts in LED
center of
5
x 2
4
(TILD1X1US shown)
7
Mount
teardrop
Levels
slots
6
