Installation Instructions
CSPS/CSPR
7
Assembly And Installation
CSPS Installation
1.
Position accessory wall plate (A) onto wall at desired
mounting location. Use a level to ensure of an even mount.
(See Figure 1)
2.
Mark and drill four 1/2" (12.7mm) holes at the desired
mounting locations. (See Figure 1)
Figure 1
3.
Hold metal channel on 1/4"-20 anchor (J) flat alongside
plastic straps and slide channel through hole. (See Figure
2)
Figure 2
4.
Holding plastic straps on anchor (J), pull anchor away from
wall until channel rests flush behind wall. (See Figure 3)
5.
Slide plastic cap on anchor (J) towards wall until flange of
cap is flush with wall. (See Figure 3)
Figure 3
6.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 4)
7.
Repeat Steps 3 through 6 for the other mounting holes.
Figure 4
8.
Place mount over anchors and align mounting holes on
mount with holes in anchors. (See Figure 5)
9.
Use four 1/4-20 x 1 3/4" Phillips pan machine screws (K)
and four 1/4" washers (L) to secure wall plate (A) to anchors
(J). (See Figure 5)
Figure 5
2
1/2" (12.7mm)
(J)
Drywall
Plastic Straps
3
(J)
Plastic Cap
Drywall
SIDE VIEW
4
5
Plastic Straps
Drywall
Plastic Cap
SIDE VIEW
6
(L) x 4
6
(K) x 4
(A)
(J) x 4
