Preparing the Ceiling
Warning
Follow standard safety practices when using ladders or lifts. Failure to do so can result in injury or death.
We like you, we don't want you to be injured or killed, and we hope you understand the gravity of the
situation.
Note
All above-ceiling work must conform to local building codes and should be performed by qualified
personnel.
If installing in a hard ceiling:
Using the tile brace as a template, make a hole in the ceiling where the speaker will be mounted.
If installing in a suspended tile ceiling:
1. Remove the ceiling tile where the speaker will be mounted, and make a hole in the ceiling tile using
the tile brace as a template.
2. Reinstall the ceiling tile and position the tile brace.
3. Optional but recommended: Secure the tile support brace to the building structure using appropriate
hardware such as Chief’s “Speed Connect Hardware Kit,” part number CMSHDW. The ends of the
tile brace have holes to accommodate support wires.
Connecting the Cable
1. Loosen the screw holding the connector cover in place, and pivot the cover outward.
2. Loosen the screw securing each side of the cable clamp to the speaker body, and loosen the two long
clamp adjustment screws.
3. Route the cable through the cable clamp and connect it.
4. Tighten the clamp adjustment screws until the cable is held securely in the clamp. Then tighten the
screws securing the clamp to the speaker body.
5. Move the connector cover back into place and tighten the screw.
Complete Manual for the EasyIP Ceiling Speaker D Recessed Speaker with Dante Networked Audio
5
