LEGRAND 6830 31, User Manual

Page: 24 / 68

24
After replacing the batteries, it is
recommended to check the Date and
Time of the Chronothermostat.
• Use the
ÉÑ
keys to select the “Timed” mode.
• Use the
ÅÇ
keys to increase or decrease the value of the preset tem-
perature.
• Use the OK key to confi rm
When confi rming, the Timed Mode setup menu will be displayed;
• Use the
ÉÑ
and
ÅÇ
keys to set the temperature and hours/minutes
ÅÇ
increases/decreases the selected digit
ÉÑ
toggles from temperature to hours/minutes
• Use the OK key to confi rm
The Manual mode Icon and the time to the end of the Timed programme
will be displayed.
The Chronothermostat is now working under the new preset mode.
Change the Timed mode
• Use the
ÉÑ
keys to select the “Antifreeze” mode.
• Use the OK key to confi rm
The display shows the Antifreeze mode Icon for Winter functioning or the
Thermal protection mode Icon for Summer functioning.
The Chronothermostat is now working under the new preset mode.
Change the Antifreeze mode
• Use the
ÉÑ
keys to select the “Off ” mode.
• Use the OK key to confi rm
The Off mode Icon will be displayed.
The Chronothermostat is now working under the new preset mode.
Change the Off mode
Replacing the batteries
Putting in the batteries
- Remove the Chronothermostat from the
base
- Put in the two long-lasting LR6/AA (recom-
mended for photographic applications) 1.5V
alkaline batteries according to the polarity
shown in the drawing.
When the symbol below is displayed it is necessary to replace the
batteries. If fl ashing, the device will not work, thus the batteries need to
be replaced. The “dead battery” signal appears about one month before
the batteries totally run out.
When replacing the batteries, the data stored will be saved.
The batteries will last for at least 1 year. The duration depends
on the type of batteries, on the screen saver selected (see pag.
26) and on the display activation time (about 5 seconds every
time a key is pressed).
Introduction and standard functions