6
CONNECTING THE CONTROL BOARD'S TRIGGER OUTPUT (FOR COMPATIBLE CAMERAS)
NOT USED
PoE+ OUTPUT
IEEE 802.3 at
PoE+ INPUT
IEEE 802.3 at
PoE power unit
Fan
Terminal block
12 IR LEDs
Camera
mounting
platform
The main control board is located below the camera's mounting platform
See below for more information
Heating 12 VDC
IR adjust
(turn clockwise to
increase power)
Camera ICR control
- noir (earth)
- red (+5 V)
- orange (0 V)
Caution: The camera ICR control output is used to synchronise the transition
from colour mode to black and white mode depending on the lighting of the
LEDs on the housing:
- If the LEDs are lit, the camera is in black and white mode.
- If the LEDs are off, the camera is in black and white mode.
Type of connection depending on the camera:
- If the IR trigger signal is in the high position (+5 VDC), connect the red and
black wires to the camera's D/N +/- trigger line.
- If the IR trigger signal is in the low position (+0 VDC), connect the orange and
black wires to the camera's D/N +/- trigger line.
E.g.: Connecting a camera housing: 4 306 60 and 4 306 61: - Orange wire to NA port.
- Black wire to G port.
POE INJECTOR
POWER &
DATA OUT
DATA IN
ACTIVE
POWER
AC IN
100 ~ 240V
104 mm
38 mm
138 mm
PoE injector specifications
Input power requirements
AC input voltage:
100 - 240 VAC
AC frequency:
50 - 60 Hz
AC input current:
2A at 100 VAC, 1A at 240 VAC
Power over LAN output specification
Pin assignments and polarity:
(+) 4/5 (-) 7/8
Output voltage:
Aggregate power: 30W +/- 5 % (48Vdc +/- 2V)
Output current:
0 - 1A +/-5 %
Mechanical specifications
Dimensions:
(H) 3.8 cm × (W) 10.4 cm × (D) 13.8 cm
System indicator:
AC power (green)
Active power (red) 0.05 A<Io<1 A
Overcurrent protection (flashing red)
