3
A
+
+
A
2
B
C
C
A
1
B
A
1
B
C
A
2
To complete your installation,
briefly
press the configu-
ration of the
Module Control
or the middle of
the wire-
less Home / Away master switch.
All the indicator lights on the products switch off
Complete the installation
3
< 1 s
Or
< 1 s
+
If necessary, erase the configuration of the wireless
batteryless control (factory reset)
While holding the "setup" button on the wireless batteryless
control, press the "Wake Up" button for 5 seconds.
Confirm that your control is correctly reset by making an
"Wake Up" command, then "Sleep"
5 s
Pair the wireless, batteryless switch to your connected installation.
Make sure that the indicator lights on the wired products are green and not flashing.
If not, go back to step
1
.
2
Tap 3 times any wired product "with Netatmo" with the wireless, batteryless "Wake Up/Sleep control". The light of the
wired product flashes rapidly.
For the specific case of the latching relay, press the main button of the latching relay until the configuration indicator
flashes slowly in blue, release it then tap it 3 times with the wireless, batteryless "Wake Up/Sleep control". The indicator
light of the wired product flashes rapidly.
While holding the "setup" button on the wireless, batteryless control, briefly press the "Wake Up" or "Sleep" control on the
wireless batteryless control.
The indicator light of the wired product will briefly turn blue, and then will turn green again.The pairing was successful.
Complete the configuration of the scenarios using your HOME + CONTROL application, menu "Settings", then
"Scenarios"