STYLE™
foundation
design
99301567-d
16
REMOTE CONTROL PROGRAMMING
(1 remote control - 2 bases)
Program One Remote to Operate Two Bases (Tandem
Syncing)
- perform the following numbered procedure.
Note: Make sure both remotes are in “press & hold” mode
and both bases are fl at before beginning procedure.
BASE 1
BASE 2
STEP 1
Unplug both bases from electrical power source.
STEP 2
Choose base 1 remote control. Retain base 2 remote
as a spare.
STEP 3
Operate remote control to verify programming.
NOTE: Remote control is factory programmed to
operate one base. If reprogramming is required,
refer to
Remote Control Programming - 1 remote
control to 1 base.
FIGURE 11
DUAL SYNC
CABLE
MALE PLUGS
FEMALE PLUG
STEP 6
Repeat Step 5 with base 2, using the remaining male
and female plugs of the dual sync cable.
STEP 7
Turn both bases over so they are resting on their legs.
CAUTION: MAKE SURE CABLE IS CLEAR OF BASE AND
FREE OF ANY PINCH POINTS.
STEP 8
Plug both bases into electrical power source.
STEP 9
Operate both bases with the remote control.
NOTE:
If bases do not operate in unison with the remote,
verify dual sync cable connections are fully seated
in both MFP ports. Unplug both bases, wait 10
seconds, then plug them back in.
STEP 4
Locate dual sync cable (
FIGURE 11
).
MFP
PORT
STEP 5
Position both bases on their sides. On base 1,
unplug the splitter cable from the MFP port of
motor. Insert one male plug of dual sync cable into
the MFP port of motor and female plug into splitter
cable (
FIGURE 12
).
FEMALE PLUG
MFP PORT
plug male end
of dual sync
cable in here
plug female end
of dual sync cable
into this end of
splitter cable
SPLITTER
CABLE
MOTOR
FIGURE 12
MFP PORT
