15
STYLE™
foundation
design
99301567-d
REMOTE CONTROL PROGRAMMING
(1 remote control - 1 base)
Program One Remote to Operate One Base
- perform the
following numbered procedure.
STEP 1
Remove the battery compartment door from the
remote control (
FIGURE 9
).
STEP 4
On the remote control, press and hold the
learn
switch
(
FIGURE 9
)
until the underbed lighting
goes off
.
STEP 5
Operate remote control to verify programming.
One remote control is now programmed to
operate one base.
FIGURE 9
LEARN
SWITCH
BATTERY
COMPARTMENT
DOOR
STEP 2
Make sure adjustable base is plugged into
electrical power source. Position base on its
side. Locate the power down device (
FIGURE
10
).
STEP 3
Push the power down reset button
in
two
times in rapid succession (
FIGURE 10
). The
underbed lighting will come on.
FIGURE 10
RESET
BUTTON
RESET LIGHT
MOTOR
attached to
underside
of adjustable base
POWER DOWN
DEVICE
factory pre-wired
to motor
