Legacy Stoves VF2500, Installation And Operator'S Manual

Page: 26 / 37

Pusher Block Maintenance
When left standing for long periods with wet coal,
the pusher block will rust and corrode, causing it to
stop. If the stoker is then turned “on”, damage to the
pusher assembly and feed motor will result.
is will
be considered neglect and will void the warranty on
those parts. If the unit has not been burned for a
period of time, always check to see if moving parts
are free before using.
is can best be determined by
shaking the adjuster rod.
Filter Installation and Replacement
e 6lter is located at the rear of the furnace at the
top of the distribution blower housing. To replace or
install the 6lter, remove the old 6lter by sliding it
vertically out of the 6lter rail at the rear of the
furnace. Insert a new 6lter into this same area, until it
is Lush on either side.
Legacy Stoves recommends a 6lter be chosen with
a MERV rating of 5 – 12. MERV is an acronym for
Minimum EMciency Reporting Value. A higher rating
indicates the 6lter will capture 6ner particles. Filters
with higher ratings may result in less air-Low in your
duct. Frequent replacement will help maintain
eMcient heating.
Note: It is recommended that this filter be
replaced monthly during periods of use. Filter
size is 14 X 20 X 1. Filters are to be UL
Class 2 minimum. Testing was performed
according to UL standard 900 and CAN-4-
S111.
CAUTION: INSPECT FLUE PIPES, JOINTS, AND
SEALS REGULARLY TO ENSURE THAT SMOKE
AND FLUE GASES ARE NOT DRAWING INTO
THE DWELLING.
CLEANING OF THE HEAT EXCHANGER, FLUE
PIPE, CHIMNEY, AND DRAFT INDUCER IF USED,
IS ESPECIALLY IMPORTANT AT THE END OF
THE HEATING SEASON TO MINIMIZE
CORROSION DURING THE SUMMER MONTHS
CAUSED BY ACCUMULATED ASH.
DO NOT USE CHEMICALS OR FLUIDS TO
START A FIRE.
DO NOT BURN GARBAGE, GASOLINE,
NAPTHA, ENGINE OIL, OR OTHER
INAPPROPRIATE MATERIALS.
- 26 -