________________________________________________________________________________________________
_______________________________________________________________________________________________
Operation Manual
Page 8 of 10
Section 4: Operation Procedure
Step 1
: Lower the saw blade by rotating the
hand wheel
Step 2
: Insert the tube, to the position where the blade would cut off the tube, and then fasten the clamp.
Step 3
:
Apply lubricant to the saw blade for each cut.
Step 4:
Rotate the motor clockwise about 45° until the saw blade reaches the tube. Rotate the hand wheel
to adjust
the cutting depth, normally there is about 1-2mm teeth length into the tube. Then keep rotating the motor to
finish the cutting.
