the Out of Range feature turned on.
TURNING THE OUT OF RANGE OFF
•
Remove all the coasters from the charging unit or unplug the power supply that is
connected to the charging base
•
At the “Out of Range” menu, press “#/Select” key to turn the Out of Range OFF.
•
Press “ENTER” key 3 times. After sending the signal, all the coasters will light up once to
tell you that they received the new code.
•
Press “CANCEL” key to exit the system programming menu.
To test the coasters with Out of Range off, unplug the power supply that is connected to the
transmitter. After 30 - 45 seconds, all the coasters should not play the melody since the Out of
Range was turned off. If all or some of the coasters are playing the melody, repeat the
procedure above. If none of the coasters are playing the melody, return all the coasters to the
charging base or plug the power supply. Plug the power supply of the transmitter. The
coasters are ready to receive the page with the Out of Range feature turned off.
7) Frequency Table
Frequencies are selectable as below:
0. 450.0000 6. 459.0500
1. 450.3250 7. 462.5750
2. 452.5750 8. 467.7500
3. 453.0250 9. 467.8000
4. 454.5750 10. 467.8500
5. 457.5750 11. 467.8750
Troubleshooting
Transmitter will not display anything
a. Make sure there is power to the outlet
b. Check all connections.
If you try all this and the transmitter still wont power up your power supply may be bad. If display is still blank, call
LEETEK.
Before you call, try some of the following suggestion
*Remember that the capability of your system will be affected by: Foil backed wallboard, Metal mesh,
wire reinforced glass, metal sheeting, large mirrors, suspended ceilings, lift shafts etc. These can all
reflect and thereby reduce the signaling capability of the transmitter. A little forethought prior to
installation, coupled with a few tests, can normally avoid most of these problems.
1.Read through the manual. Answers to most questions can be found there.
A trouble shooting section further assists you in diagnosing the problem.
2. IMPORTANT NOTICE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
