4) Set Pager Alert (
Factory Default: Flash & Vibe)
With this feature you have the option of changing the way your coasters alert the guest.
Be sure that all coasters are returned before performing this procedure.
To change the alert mode of your coasters follow these instructions
z
Remove all the coasters from the charger base or unplug the power supply that is connected to
the charger bases.
z
At the “Set Pager Alert” menu, press the “#/Select” key to scroll through the different alert
options.
z
After making a selection, press the “ENTER” key 3 times. After sending the code, the coasters
will now respond with your new selection.
z
Press “CANCEL” key to exit the system programming menu
z
Return all the coasters to the charger base or plug the power supply. The coasters are ready to
receive the page with the new alert.
5) Setting the Duty Alert
(Factory Default: OFF)
This feature enables your Transmitter to send a page, at a preset time, to a certain pager to remind
them of a duty required of them. For example, a buzzer can receive a page every 60 minutes to
remind him to check the restrooms.
You can assign up to 3 different pagers to be duty alert pagers.
Programming the duty alert
•
At the “Duty Alert” menu, press “#/Select” key to turn the duty cycle “ON” and press the
“ENTER” key.
•
Enter the duty pager number and press “ENTER” key.
•
Enter the cycle time (in minutes) and press the “ENTER” key.
•
Enter the numeric message.
•
After setting the duty alert function, press “ENTER” Display will show “Duty _ _ saved”
•
Press “CANCEL” to exit or press “ENTER” to continue entering the next duty pager
information.
6) Setting the “Out of Range”
With this feature, the coasters will play a melody when taken Out of Range of the transmitter to
inform the guest that they are Out of Range and will miss their page. The melody will only stop, when
they return back within range
.
TURNING THE OUT OF RANGE ON
•
Remove all the coasters from the charging unit or unplug the power supply that is
connected to the charging base
•
At the “Out of Range” menu, press the “#/Select” key to turn the Out of Range ON.
•
Press the “ENTER” key 3 times. After sending the signal, all the coasters will light up
once to tell you that they received the new code.
•
Press “CANCEL” key to exit the system programming menu.
To test the coasters with Out of Range on, unplug the power supply that is connected to
the transmitter. After 45 – 60 seconds, all the coasters will play a melody since they are not
receiving a signal from the transmitter. Plug in the power supply back into the transmitter.
After a few seconds, all coasters will stop playing the melody. Return all the coasters to the
charging base or plug the power supply. The coasters are ready to receive the page with
