Leem HMM-16FX, Owner'S Manual, Page: 10 / 24

8
HMM-16FX
Front Panels
Front Panels Controls
1. INPUT/OUTPUT CONNECTORS
(3). CHANNEL INPUT JACKS
These are unbalanced stereo line input jacks.
Two jack types are provided: phone type and
RCA pin type. Use these jacks to input stereo
signals, input the L signals to the L channel out-
put and the R signals to the R channel output.
NOTE:
(
4). STEREO RETURN L (MONO), R JACK
These are unbalanced 1/4” TRS phone-type line input
jacks. The signal received by these jacks is sent to the
MAIN bus and AUX1/AUX2 buses. These jacks are
typically used to receive a return signal from an exter-
nal effector (reverb, delay, etc.)
NOTE:
(5). TAPE IN JACKS
These RCA pin jacks input a stereo sound source.
MONO
MONO MONO
AUX RETURN
TAPE IN REC OUT
GROUP OUTPUT
FOOT SWITCH MAIN OUTPUT
CONTROL ROOM
LINE 9
LINE 10
9/10
MIC
LINE 11
LINE 12
11/12
LINE 13
LINE 14
LINE 13
LINE 14
LINE 15
LINE 16
13/14
MIC
LINE 15
LINE 16
15/16
AUX 1 SEND
AUX 2 SEND EFX SEND
HEADPHONE
LINE
INSERT
5
MIC
LINE
INSERT
6
MIC
LINE
INSERT
7
MIC
LINE
INSERT
8
MIC
LINE
INSERT
1
MIC
OUT IN
LINE
INSERT
2
MIC
LINE
INSERT
3
MIC
LINE
INSERT
4
MIC
(1). CHANNEL INPUT JACKS
MIC JACKS
These are balanced XLR-type input jacks.(1: Sleeve,
2: Hot, 3:Cold)
BALANCED LINE IN JACKS
A standard 1/4” TRS phone jack is used for balanced
or unbalanced line level signals. Examples of line level
signals include most electronic keyboards, synthesiz-
ers, turn-tables (with appropriate pre-amps), tape
decks and the line outputs from other mixers.
(
2). CHANNEL INSERT I/O JACK
These are input/output jacks located between the
head-amplifier and the high pass filter.
These jacks can be used to independently connect
these channels to devices such as graphic equalizers,
compressors, and noise filters. These are 1/4” TRS
(tip, ring, sleeve) phone jacks that support bi-direc-
tional operation.
NOTE: Connection to an INSERT I/O jack requires a
special separately-sold insertion cable such as illus-
trated below.
Tip:Output(Send to external device)
Sleeve:Ground
Ring:Input(Return from external device)
These jacks can also be used as an auxiliary
stereo input. If you connect to the L (MONO)
jack only, the mixer will recognize the signal
as monaural and will propagate the identical
signal on both L and R jacks
1.Where a channel provides a phone jack
and an RCA pin jack, you may use either one
of these jacks but you may not use both at
the same time. Please connect to only one of
these jacks on each channel.
2.The phone type jacks for CH9/10and11/12
also support monaural input. Specifically, if
you input only into the L(MONO) jack of either
pair (while leaving the R jack empty), the mixer
will propagate the same signal through both
L(MONO) and R inputs.
1
11
12 10 8 7 4
5 6
2
3 9
502-M1636FXB-2161_01.indd 8 2007/3/8 ¤U¤È 02:11:12