/SOS (red) LED on, finally 0~9+confirm/delete white backlight on,totally it takes
about 2 seconds after device power on. Buzzer long beeps 1 time.)
SmartStart Inclusion
Add the Keypad into the Z-Wave network via SmartStart:
1.
Add Keypad DSK into the primary controller SmartStart Provisioning List
(If you don’t know how to do this, refer to its manual).
2.
Power on the Keypad again.
3.
The Keypad will send “Z-Wave protocol Command Class” frame to
start SmartStart Inclusion.
4.
Network green LED will flashing at every 1 second to indicate that the
inclusion is working, and solid green LED 3 seconds for indicate the
inclusion is successful, otherwise the LED will be soild yellow in which
you need to repeat the process from step 2
Note: Keypad will reset itself to factory default by sending “Device Reset
Locally CC” when it is included into a non-security Z-wave network.
DSK QR code is on the left side of the product with laser printing.
User should follow the procedure in the section below if the controller
does not support SmartStart inclusion.
Short press pair
button three time
Add the Keypad into the Z-Wave network:
1.
Set the Z-Wave network main controller into learning mode (see Z-Wave
network controller operating manual).
2.
Trigger this action.
3.
Network green LED will flashing at every 1 second to indicate that the
inclusion is working, and solid green LED 3 seconds for indicate the
inclusion is successful, otherwise the LED will be soild yellow in which you
need to repeat the process from step 2.
Remove the Keypad from a Z-Wave network:
1.
Set the Z-Wave network main controller into removing mode (see Z-Wave
controller operating manual).
2.
Trigger this button action. the Network LED will flashing at every 1 second.
3.
If the removing is successful, the LED will solid green for 3 seconds. If the
removing is failed then LED display yellow for 3 seconds, otherwise you
need to repeat the process from step 2.
Note: Keypad will start SmartStart Inclusion when it is removed from a Z-wave
network.
Press pair button
and hold more
than 5 seconds
Network Indicator green LED will fast blinking and backlight will ON for 2
seconds. Buzzer beeps 1 times after reset successful.
Reset the Keypad to factory default.
1.
Device will reset itself to factory default by sending a “Device Reset
Locally Notification” to gateway.
2.
If triggered the factory reset, the network connection led will solid green
while factory reset is completed.
Note:
Please use this procedure only when the network primary controller
is missing or otherwise inoperable.
