mounting the sensor and magnet ensure the marks on the sensor and magnet are aligned (Figure 2). The LED on the sensor
should be positioned at the top when possible. Ensure you have
space to slide open the battery door when positioning the sensor.
3.
Peel the paper off one side of the double-sided tape provided,
attach to the back of the sensor and press firmly for a few seconds.
Peel the paper off the back of the sensor, position the sensor to the
door/window fixed frame, be sure to position the sensor in the
location you have verified to provide good communication with the
home controller or security system, press firmly for a few seconds.
4.
When mounting the magnet add spacers as necessary to
ensure the back of sensor and magnet are on the same horizontal plane. Peel the paper off one side of the double-sided tape
provided, attach to the back of the magnet or spacer and press firmly for a few seconds. Peel the paper off the back of the
magnet or spacer, align the magnet to the sensor and press firmly for a few seconds.
1.
The LED on the sensor will remain off during the normal operation.
2.
The sensor is equipped with a tamper switch. Sliding the battery cover to the open position will cause a trouble fault on the
home controller or security system. Sliding the cover open will also activate the communication test for 30 seconds. Refer
to the Installation section for details on this feature. Once battery cover is closed the trouble will clear.
If the sensor needs to be factory defaulted (for example to prepare it for joining with a home controller or security system):
1.
Enter the home controller or security system and use the device menus to delete the sensor that requires a factory reset.
2.
Slide the battery cover to expose the battery and the reset release
button, Figure 3.
3.
Depress the small reset release button while continuing to the slide
the battery cover until you expose the red reset text. You may
need to use a small screwdriver or paper clip to press the release
button as shown in Figure 4.
4.
Remove the battery, wait 10 seconds and then re-insert the battery.
5.
Once the battery is installed slide the battery cover such that the
reset button is no longer exposed but such that the cover is not
completely closed, Figure 5.
Note:
You must perform this
operation within 4 seconds of
installing the battery.
6.
The factory reset
process will take
approximately 1 minute,
during this time the LED will remain solid green, if the LED does not remain solid
green this mean you did not release the reset in less than 4 seconds and must repeat
steps 1 thru 4.
7.
Upon completion of the factory reset the LED will blink green three times
every 5 seconds indicating it’s ready to be paired.
If the home controller or security system indicates the battery is low, the battery must be replaced.
1.
Purchase a CR2 Battery.
2.
Once you have received the CR2 battery, slide the battery cover to expose the battery as shown in Figure 6, remove the old
battery, wait 10 seconds and install the new one.
3.
Once the battery is installed slide the battery cover to close the device. The
LED will illuminate green for 2 seconds and will automatically reconnect to
the
home controller or security system and return to normal operation.
Reset to Factory Defaults & Reboot
Operation
Replacing The Battery
