7
6.
Product Usage
Function of Action Button:
6.1
All functions of each trigger:
Function Of Action
Trigger
Description
Power on
In the network:
Send Battery report and Wake up notification, the LED
turn on within 1 second.
Not in the network:
Only the LED turn on within 5 second.
Short press
button one time
Add the Motion Sensor into the Z-Wave network:
1.
Power on your Motion Sensor, and let your Z-Wave controller into
add/inclusion mode.
2.
Implement the button action, the Motion Sensor will send out a node
info security CC in command class list (Security inclusion), the LED
will be fast blink for 60 seconds.
3.
If the inclusion is successful, the LED will be turn on within 2 seconds.
If failed, LED will be turn off forever, and please repeat the steps in
above.
Remove Motion Sensor from a Z-Wave network:
1.
Power on your Motion Sensor, and let the Z-Wave primary controller
into remove mode.
2.
Press the button on the Motion Sensor, the LED will be turn on for 60
seconds.
3.
If Motion Sensor has been successfully removed from your Z-Wave
network, the LED will be fast blink 2 seconds. If failed, LED will be
turn off forever, and please repeat the steps in above.
Short press
button three time
In the network:
Send Wake up notification, and LED will fast blink when
sending data, send over then the LED turn off.
Not In the network:
NOP.
Press and hold
more than 5
seconds
Reset Motion Sensor to factory default.
NOTE:
1. Triggering this action, in 5 seconds LED will be fast blink. The LED
will be turn on within 2 second until hold time is equal to 5 seconds.
Motion Sensor will send “Device_Reset_Locally” to the main
controller and exclude from the Z-Wave network when the button is
released, this procedure will reset the sensor to factory default.
2.
Please use this procedure only when the network primary controller is
missing or otherwise inoperable.
3.
When not in the network, ignore this operation.
