4
Position 5 or 6
May be used for bullet seating. If you are seating and crimping
in one operation, use position 6 as it gives you easy access to
manually place the bullet. If you are Factory crimping, this die
will always be installed in postion 6.
Rifle Easy Adjust
Dead Length Bullet
Seating Die
Adjusting
Screw
Rifle Collet Factory
Crimp Die
Position 4
Works well with a
powder check die or
inline bullet feed die
Handgun Bullet
Seating Die
Adjusting
Screw
Adjusting
Screw
Pistol Carbide Factory
Crimp Die
TOOL HEAD POSITION & INITIAL SETUP
Position 5 or 6 = Bullet Seating Die
Position 4 = Accessory
Position 6 = Factory Crimp Die
We suggest Lee dies as they use a powder through expanding die to conveniently charge your brass while expanding the
case mouth. Lock rings are not required when utilizing the spline drive breech lock bushing.
Follow the reloading die instructions for the type and brand of dies you have selected.
The only instructions special to the Six Pack are highlighted here.
How to install Breech Lock Bushings
Drop the breech lock bushing into the press frame, and rotate the
bushing 1/6 of a turn clockwise finger tight. Remove by rotation
1/6 turn counterclockwise and lifting from the frame. To prevent
die movement, install and remove by
grasping the spline on the
bushing
. A handy die wrench is included.
6
