The lamp case
Connect the ba>ery to the lamp case. Be careful to fit the white markings on the con-
tacts to each other; if they are incorrectly fi>ed and forced together the contact pins
might break.
Right
Wrong
The switch is placed at the bo>om of the lamp case. Light the lamp by pressing the
switch unDl the lamp turns on (1-3s). The lamp starts on the lowest effect, default at
10%, use short clicks to up the effect. Turn it off by pressing the switch unDl it turns
off.
The lamp has three power modes controlled by the switch on the back of the lamp
house. Push the switch during 1 - 2 seconds to turn on and turn off the light respecD-
vely. It always lights up at the lowest power. To switch between power modes press
the bu>on for about 1/10 of a second. If you use the maximum power you need to be
moving outdoors so the lamp cools down sufficiently from the moving air.
Do not use the lamp indoors on full effect. It is important that enough cool air can
circulates the casing to avoid overheaDng. If the light becomes warmer than 75° C, it
automaDcally drops to a lower power, first to 40% and if the high temperature per-
sists aZer 2 minutes it drops further to 10%. There is an emergency cut off point, if
the lamp has been covered, or for any other reason, reached 95° C it will be comple-
tely turned off.
The lamp case can easily be removed from the headgear by lightly press the top part
of the a>achment plate and simultaneously pull the lamp upwards.
The lamp is water resistant, but should not be used underwater.
!
Batteries
The main baDery
is a Li-Ion ba>ery; these are characterized by a high capacity and
low self-discharge. It is carried conveniently in a rear harness, waist or in a pocket. It
