HUEDA™ RF Receiver/Controller
1/4
Copyright © 2016 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
Model:
H-R009PD
Ÿ
This product is intended to be installed and serviced by a qualied licensed electrician. Install in accordance with the
National Electric Code, and local regulations. Disconnect power before installing or servicing.
Only power with a
regulated (listed) constant voltage Class 2 power supply (12-24V DC).
Never use this product with dimmable or
magnetic dimmable power source(driver).
Ÿ
Ensure applicable wire is installed between driver, xture, and any controls in between. When choosing wire, factor in
voltage drop, amperage rating and type (in-wall rated, wet location rated, etc.). Inadequate wire installation could
overheat wires and cause re.
Ÿ
This product is rated for indoor installation and can be used for dry locations. Avoid the direct sun light.
Ÿ
Do not modify this product beyond the instructions in this guide or the warranty will be voided.
Ÿ
Wiring diagrams in this installation guide for basic installations. Please carefully review your installation before
proceeding.
Ÿ
Always be sure to mount this unit in an area with proper ventilation to avoid overheating.
Ÿ
Please check if the output voltage of any LED power supplies used comply with the working voltage of the product.
Ÿ
Never connect any cables while power is on and always assure correct connections to avoid short circuits before
switching on.
Ÿ
Please ensure that the cable is secured tightly in the connector
Ÿ
For updated information please consult your supplier.
Safety & Warnings
1-800-387-4081
ledworldlighting.com ledworld.ca
Before you begin, read all warnings and installation instructions (as they may have been updated from previous versions ).
Improper installation(s) present hazards, which can result in personal injury or property damage.
Warning
:
Input voltage must be identical to output voltage
of the LED Fixture!
Exposed wire should not be more than 6- 8 mm long
tinned. Do not allow Wires to cross and insure all
exposed wire is fully inserted into the terminals. Use 22 to
16 AWG gauge wire for output terminals.
WIRE 6-8MM (0.25-0.30”)
1. Product Operation Overview:
R
G
B
W
L
E
D
PRI:
Uin=12-36VDC
Iin=20.5A
SEC:
Uout=4x(12-36)VDC
Iout=4x5A
Pout=4x(60-180)W
LED CONTROLLER
H-R009PD
Learning
Key
R
e
p
e
a
te
r S
ig
n
a
l
Receiver
Repeater
Jumper
Learning Button
Power Input (12/24VDC)
RGBW LED Light Output
+
R
G
B
W
V+
V+
V-
V-
Data In/Out
GND
Data+ In
Data- In
Data+ Out
Data- Out
2. Product Parameters:
Part No.
Input Voltage
Current
Output
H-R009PD
12V~36V DC
4 x 5A
4 x (60-180)W
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.2 03/03/16
