fig. 5
3
!
Before operating any maintenance disconnect the mains.
For operating a correct maintenance of the STAGE PRO SPOT 650/1000/1200 PC follow these instructions:
1) Periodically clean the in/out air grates;
2) Periodically clean the lens and the reflecting parabole (fig. 5) using antistatic cloths and products.
!
Do not absolutely use solvents or abrasive products.
MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE
1) Disconnect the unit before replacing the Lamp. Always wear protective gloves and goggles.
2) Turn, the key at the bottom of the unit, for a quarter of turn left to right (fig. 5).
3) Open the cover (fig. 4 and 5).
4) Fit the new Lamp in its socket not forcing too much (fig. 5).
!
Take care of not touching the glass of the new Lamp with the nude hands; in case it accidentally happens, clean
the Lamp bulb with a dry cloth and alcohol.
5) Close the cover, turning the key for a quarter of turn right to left.
In case of replacement of the Lamp or maintenance, never open the unit
unless are passed at least 15 minutes after it went off.
FITTING AND REPLA
FITTING AND REPLA
FITTING AND REPLA
FITTING AND REPLA
FITTING AND REPLACING THE LAMP
CING THE LAMP
CING THE LAMP
CING THE LAMP
CING THE LAMP
COLOUR FRAME
LAMP
REFLECTING
PARABOLE
LIGHT BEAM REGULA
LIGHT BEAM REGULA
LIGHT BEAM REGULA
LIGHT BEAM REGULA
LIGHT BEAM REGULATION
TION
TION
TION
TION
Correct regulation of the light beam:
•
Turn the knob placed on the rear part of the unit (fig. 4);
•
Turning the knob from right to left the light beam amplitude is reduced, from left to right it is enlarged.
To avoid any bad performance of the unit or the Lamp breakage
damaging the optics of the STAGE PRO SPOT 650/1000/1200
PC, replace the lamp as soon as its maximum average time
ends. The lens must be replaced when is evidently damaged
and if its efficiency has been reduced, for example from slits or
deep cuts.
KEY TO OPEN THE
LAMP ROOM
COVER
Rev.
12
/200
5
Working to make its products always more perfect, LED reserves the possibility to make technical changes during the production. The technical features and the drawings on this
manual are not binding for LED and they could be changed at any time without notice. LED it is not responsible for any inconvenience caused by an improper or different use of
the unit respect to the one for what it has been made.
IMPORTANT
!
LED s.r.l.
: ZONA P.I.P. Contrada Pozzillo - Viale Saponaro D. Lotto G, N. 8 - 70016 Noicattaro (BA)
-
Italy
Tel.
: +39/080 9906090
Fax.
: +39/080 9906092/3
Web Site
: www.ledsrl.it
