www.globallightllc.com
Fax: +971 4 341 10 90
Tel: +971 4 340 44 58
INSTALLATION GUIDE
•
Step 3:
(
A) Attach a junction box near by the fixture and make all
connections inside the junction box, or keep
all wiring connections in the sleeve, below
the light fixture.
(B) Connect the fixture input cable to
the 24V DC supplied wires using minimum
2.5mm cable.
(C) Solder the connections or use terminal
blocks.
(D) Wrap the connections with 3M waterproof tape &
electrical tape.
•
Step 4:
Place the fixture in the sleeve by pressing linearly and equal pressure from both side.
Step 1
Step 4
Step 3
Step 2
Find the location where the linear in ground light has to be installed. Install suitable wiring from the Power supply
(24V DC) to the light fixture. Do not exceed 30 meter distance between power supply and light fixture. Keep the
Power supply (24V DC) inside the junction box or Mount it on the wall in a DB box.
•
Step 1:
Dig the linear cut approximately 20cm deep before installing the Sleeve.
•
Step 2:
Install the sleeve in the ground. Depending on the type of tile thickness, raise the sleeve by
1 - 2cm above the surface.
#Note:
The lighting fixture should be installed only after the completion of all mechanical and civil works at site.
Single Color - Diagram
RGB - Diagram
# up to maximum power supply rated power
# up to maximum power supply rated power
# up to maximum power supply rated power
# One remote control 10 Zones