Digital Hybrid Wireless
®
UHF Belt Pack Transmitter
Rio Rancho, NM
11
Selecting Audio Polarity (Phase)
Audio polarity can be inverted at the transmitter so
the audio can be mixed with other microphones with-
out comb filtering. The polarity can also be inverted
at the receiver outputs.
Compat
StepSiz
Phase
Locked
Phase
Pos.
Neg.
Adjusting LCD Backlight
For viewing the LCD in dimly lit conditions, the back-
light can be turned on continuously or set to turn off
automatically after either 30 seconds or 5 minutes.
Phase
Locked
Backlit
Rf On?
Backlit
On
30 sec
5 min
RF ON/OFF on the Menu
The RF output of the transmitter can be turned off
and on with a menu item on the LCD to switch from
the standby mode to the operating mode.
Backlit
Rf On?
BatType
Default
Rf On?
No
Yes
Selecting Battery Type
The voltage drop over the life of different batteries
varies by type and brand. Be sure to set the correct
battery type for accurate indications and warnings.
The menu offers alkaline or lithium types.
Backlit
Rf On?
BatType
Default
BatType
Alk.
Lith.
If you are using rechargeable batteries, it is better to
use the timer function on the receiver to monitor the
battery life rather than the indicators on the transmit-
ter. Rechargeable batteries maintain a fairly constant
voltage across the operating time on each charge
and stop working abruptly, so you will have little or
no warning as they reach the end of operation. The
timer is available on all Lectrosonics Digital Hybrid
Wireless
®
receivers.
Restoring Default Settings
This is used to restore the factory settings.
Backlit
Rf On?
BatType
Default
Default
settings
No
Yes
IR (infrared) Sync
The opening on the side panel is an IR port for quick
setup using a receiver with this capability. The trans-
fer is initiated with a switch on the receiver.
FCCID:DBZLMBC1
Lectrosonics, Inc.
Made in U.S.A.
IC: 8024A-LMBC1
614.4 - 691.1 MHz
Model: LMBC1
S/N XXXXX
IR Port
The receiver can transfer the settings for Frequency,
Step Size and Compatibility mode to the transmitter
via the IR ports. When the settings are successfully
transferred,
OK
will appear on the transmitter LCD.
If a mismatch exists, an error message will appear
on the transmitter LCD indicating the nature of the
problem.
IR Sync
BLOCK
Mismatch
IR Sync
COMPAT
Mismatch
IR Sync
OK
