LeCroy DA18000AC, Instruction Manual

Page: 29 / 34

Specifications
DA18000AC-OM-E Rev A
8-1
8
Specifications
The specifications are valid for probes when the following conditions have been met:
• The probe has been operating for at least 30 minutes in an environment, which is
within the operating environmental specifications.
• The probe has been calibrated within the last 12 months. Calibration was performed
in a controlled environment of 25 °C ±5 °C.
NOMINAL CHARACTERISTICS
Nominal characteristics describe parameters and attributes that are guaranteed by design,
but do not have associated tolerances.
General
Input Configuration True differential, + and – Inputs
Input Connectors Type K (2.92 mm)
The type K input leads will connect directly to
female type K connectors on the system under
test.
Maximum Non-Destruct
Input Voltage, continuous 10 V
peak
Amplifier Gain ~ 1.2
Oscilloscope display factor is calibrated to actual amplifier gain
Input Impedance 100
Ω
, true differential
Max Input: Differential Mode
Without
÷
2 attenuators ±400 mV, 800 mV
p-p
With
÷
2 attenuators ±800 mV, 1.6 V
p-p
Max Input: Common Mode
Without
÷
2 attenuators 10 mV
p-p
With
÷
2 attenuators 7 V
rms
WARRANTED CHARACTERISTICS
Warranted characteristics describe parameters that have guaranteed performance. Unless
otherwise noted, tests are provided in Section 8, Performance Verification, for all warranted
specifications.
Rise Time (Amplifier only)
1
19 ps
(20-80%)
1. Measured with an SDA 18000 oscilloscope. Rise time of oscilloscope and source sub-
tracted (rms).