Lec R6014W/S, User Manual

Page: 5 / 14

Installation
Transportation
Caution: 2 people are required to
unpack and handle the appliance, it is
recommended that gloves are worn.

The appliance should be transported only in
an upright position. Do not tilt the appliance
greater than 45  . The packaging as supplied
must be intact during transportation.

After transporting the appliance, leave it for at
least 4 hours before switching on to allow the
cooling system to settle. Failure to comply
could result in damage to the appliance.

Do not move the appliance by pulling the door
or handle as it may damage your flooring and
wall coverings etc.

Empty any water in the drain tray before
moving.

Ensure the supply cable is not caught under
the appliance during and after moving.

Carefully remove all packaging materials
including the foam base, dispose of correctly.

Make sure that sufficient room is provided
around the appliance to ensure free air
circulation.

Do not place the appliance near a heat source
or in direct sunlight.

Do not put any heavy objects on top of the
appliance. It will damage the appliance.

Do not install the appliance in moist and wet
place.

Adjust the feet at front to level the appliance.
It should be installed on a smooth surface to
avoid excessive vibration and noise.

Each appliance has a climate class (shown on
the rating plate) where it indicates the
temperature range of the appliance operation
in place. The appliance may not work properly
if it is left for a long period at a temperature
outside the specified range.

Refer to section “Care and Maintenance” to
prepare your appliance for use.
Climate Class
Amb. T. (  C) Amb. T. (  F)
SN
10 ~ 32  C 50 ~ 90  F
N
16 ~ 32  C 61 ~ 90  F
ST
16 ~ 38  C 61 ~ 100  F
T
16 ~ 43  C 61 ~ 110  F
Installation
4

Screw in the two spacers (provided) at the
back of the appliance.