5)
Go to receiver type select S.Bus, X.Bus (Mode B), SPK Sat DSMX, or SPK
Sat DSM2.
6)
Go to binding select On.
7)
Then remove mini USB from port. Now reconnect the mini USB to Leap 450.
Your satellites will be blinking.
8)
Now press the bind button on your radio and satellite will go solid. Your
status light on the Leap Control Board should now be solid green.
9)
The Leap Setup Program allows you to bind and setup your radio to make
sure all controls are moving in the correct direction prior to use. For all radio
types Futaba, Spektrum, and JR the binding process can be achieved by
use of the mini USB connection on the main control board.
10) Testing of all functions can be checked prior to use via the Leap Quad
Software.
Connect Leap 450 to computer via USB port and run Leap Setup Program.
3. Transmitter Settings
Set up your transmitter according to the receiver installed. Select Airplane
mode and restore all settings to factory. Set all sub trims and expos to zero.
Channel 5 will be used for flight modes.
Using the transmitter input panel, ensure proper value and direction of
travel for all channels.
Receiver selection
Leap450 connect status
Transmitter input panel. Check the
direction of travel and value of input.
User may need to reverse direction of
travel on the transmitter
