1.
Software Installation
Under driver menu, please open Installer.exe file and install Leap 450 control
board program.
2.
Operation Instruction
Leap 450 3D Quad supports Futaba S.Bus, Spektrum Satellite receivers
DSM/DSMX, and JR X.Bus Mode B. Please refer to assembly instruction above
for wiring.
In order to bind to your satellites.
1)
Plug in the power wire (Red/Black) into the S.Bus/X.Bus port. Make sure to
check the Leap Control Board diagram for proper polarity. If using Futaba
S.Bus receiver plug the power wire into the RX S.Bus battery port. At this
time connect S.Bus wire to Leap 450 and RX S.Bus.
2)
Open Leap Firmware.
3)
Use mini USB chord to connect to Leap 450.
4)
On screen you will see in green connected when USB port is plugged into
Leap 450.
Assembled View
