+ AAA 1.5V -
+ AAA
1.5V -
4
5. Installing windshield, left/right reflector and
left/right lamp decoration
a. Refer to the figure, put the L/R reflector and L/R lamp
decoration into car body;
b. Place the windshield as shown in the picture,
then insert the wrench screw on both sides of the iron
piece and lock it with the embedded nut.
6. Installing the rear spare tire, the flagpole
base and the rear bumper decoration
a. As shown in the figure, assemble the rear spare tire,
the flagpole base and rear bumper decoration on the
back of the car body.
7. 2.4G remote control instruction
For the first time, it needs to check the
code, this product has built-in memory,
and there is no need to check the code
for battery replacement later.
1. Turn off the power and hold down the
"M" button of the remote control. After 3
seconds, the first indicator light will flash,
and then release the button.
2. At this point, turn on the power switch, the first indicator light of the remote control
changes into the state of constant light, the code successfully.
3. When the remote control is not in use, it will enter the sleep state after 10 seconds
and press any key to wake up.
4. Key function description: “▲”forward, “▼” back,“◄” turn left, “►”turn right, “S” adjust
speed,“P”brake.Press “S” key to adjust the speed, one light for low speed, two lights for
medium speed, and three lights for high speed, astern only at medium speed.
Press P to enter the brake state, all the indicators flash, press P again to exit the brake state.
forward
adjust speed
back
speed display
brake
turn right
turn left
code key
Loosen battery cover screw
put 2 AAA 1.5V batteries
