3
1. Installing front bumper and left/right
support frame
a. First place the left and right support frame
aroundthe body as shown in the figure, then
lock and fix itwith 18 M4*12 flat head screws;
b. Insert the front bumper into the body hole
and then lock it with 4 M4*12 flat head screws;
c. Place the fixed beam of the front bumper as
shown in the figure, and finally lock it with 4
M4*12 flat head screws.
2. Fix the rear support frame
a. As shown in the figure, after aligning the hole
position of the rear axle support fixing frame
and the fixed hole position of the shock
absorber spring, insert an hexagon socket fixing
screw and fix it with hex nut.
3. Installing front/rear wheel
a. As shown in the figure, first load the driving
motor, wheel and wheel cover into the iron shaft
once; then put a gasket on each side of the nut
and lock it with M10 anti-loosen nut. Finally,
clamp the wheel cap on the outside of the nut.
b. Then put a gasket on each side of the nut and
lock it with M10 anti-loosen nut. Finally, clamp
the wheel cap on the outside of the nut.
4. Installing steering wheel and cushion
a. After inserting the steering wheel into the
steering hook as shown in the figure, after
aligning the steering wheel hole and the steering
iron hole, insert an M5 screw and finally tighten
the nut.
b. As shown in the figure, place the front and rear
seats on the car body, and then lock and fix them
with 10 M4*12 flat head screws.
c. Insert the front and rear seat back into the body
hole as shown.(note: please refer to the attached
drawing for seat back removal)
