get a noise baseline (high). Turning the sensitivity switch on (up) will allow for a higher
and lower range.
Volume
Turn to the right to increase volume, turn to left to decrease. Always be sure to turn the
volume on the amplifier to the left (lowest setting) prior to each use or to powering on.
USEFUL TIPS:
T
he LT1000 comes with 2 round rings located on either side to
be used with the strap (included). It is important to use this feature when using
around construction sites and wet locations to avoid dropping and becoming
damaged.
Always carry a supply of fresh batteries. The Pool Scope™ and Pipe
Mic™ has certain voltage requirements. Once the batteries fall below the required
voltage, the signal to the headphones will cut out intermittently and/or distort. This is an
indication that the batteries should be replaced. All troubleshooting should begin by
replacing batteries with new, high quality alkaline batteries. If using noise reducing
headphones, always keep replacement batteries. As the batteries in noise reducing
headphones (such as Bose or JBL) expire, the signal heard will be intermittent and
distorted.
Troubleshooting
In the case that the pool scope or pipe mic begin to not function properly or if you
experience problems, always replace the battery in the amp with a new high quality AA
batteries. If you are using noise canceling headphones always replace with new batteries
if you begin to experience problems. As the batteries power fades, the signal will
become intermittent and subject to interference. New batteries will solve the problem. If
problems persist, test the unit with a new or another set of headphones. If a different set
of headphones corrects the problem, then the headphones or headphone cable are faulty.
Replace headphones. If the problem continues after replacing the headphones, contact
LeakTronics for assistance.
Warranty
LeakTronics warrantys it's products from electrical failure or defects in workmanship for
a period of two years following the date of purchase. Warranty claims or repairs can be
made directly through LeakTronics. Shipping costs to LeakTronics are the responsibility
of the user.
LeakTronics LT1000 Manual
Page #5
