Long press the button for (5s) to switch the working modes:
In the OFF mode, if the lighting condition is normal, it will start up automatically; or long
press the button 5s, if the light is ON and then OFF, the product will go into the ON mode.
In the ON mode, long press the button 5s, the light flash 3 times then off, the product will go
into the transport (idle) mode; if disconnected from the solar panel, the product will go into
the OFF mode directly;
In the Transport (Idle) mode, long press the button 5s, if the light flash one time and then off,
the product will go into the OFF mode; or without any operation after an hour, the product will
go into OFF mode automatically.
*
*
*
The product factory setting is using the light-operated switch to control the light (light-operated control
thresholds is 30lx). It lights up automatically at night and lights off at dawn. The light implements
multiple working modes switching through the intelligent battery control system, which prolong the
battery working time effectively. It ensures normal working even in the continuous rainy days.
4.
Operation instruction
Product installation
If the installation site is on the northern hemisphere, the solar panel should face to the south
and if it is on the southern hemisphere, the panel should face to the north. (See Picture 1)
1
.
Installation conditions
Make sure the sunlight is not blocked by any constructions or trees during the installation or it will
affect the charging and discharging efficiency of the solar power system and the operation of the
street light. (See
1.2)
Picture
Picture 1
Equator
Picture 1.2
1
2
8
7
Ø76
±
2
Ø25
600
1
2
3
4
5
2. Split type activation and installation:
Drill holes on the pole.
Firstly, determine
and mark the AE6 panel and LED light
position according to the optimum sun
radiation. Drill a Ф25mm hole approximately
600mm down from the top of the pole, where
the light is to be installed. (See Picture 2)
Attach the bracket to the AE6 unit.
Thread
the cables from the hole on the bracket and set
the proper angle in which the solar panel can
obtain maximum energy from the sun (each
scale on the bracket is 6 degree). Fix the bracket
to the solar panel by fastening a M12 × 85 bolt.
Thread 2 pieces of 2m waterproof cables through the Ф25mm hole which was made in step one
and then out from the top of the pole.
Mount the LED light:
Mount the LED light on
Connect the LED light with corresponding cables.
the pole by 4pcs M8 90 bolts.
×
The maximum torque for those M8 bolts is 14Nm. Do not surpass
this torque specification.
Mount the AE6 panel:
Connect the two cables from the top of the pole to the solar panel and install
the solar panel ensuring you do not pinch any cables use 6pcs M8 x 16 screws to secure the bracket
to the pole.
Picture 2
