CS1-D507S & CS1-D503S Closed Loop Stepper Drive User Manual
Page | 17
10. Software Configuration
The CS1-D507S & CS1-D503S is designed for simple setup and implementation. For most applications no software
configuration or tuning is needed especially when driving Leadshine stepper motors with encoders. If you want to do
fine tuning or custom configurations such as micro-step, current percentage change…, you can use Leadshine’s free
ProTuner software to make the changes.
11. Accessories
If you plan to use the ProTuner software, contact your supplier or Leadshine to purchase the RS232 cable with part
number
for connecting the CS1-D507S & CS1-D503S to a computer with Windows 7/8/10 installed. In
the case of using USB to RS232 conversion, contact your supplier or Leadshine for such a cable with part number
which has been verified working fine.
(RS232 tuning cable)
(USB to RS232 Conversion Cable)
12. Troubleshooting
In the event that your drive doesn’t operate properly, the first step is to identify whether the problem is electrical or
mechanical in nature. The next step is to isolate the system component that is causing the problem. As part of this
process you may have to disconnect the individual components that make up your system and verify that they operate
independently. It is important to document each step in the troubleshooting process. You may need this documentation
to refer back to at a later date, and these details will greatly assist our Technical Support staff in determining the
problem should you need assistance.
Many of the problems that affect motion control systems can be traced to electrical noise, controller software errors, or
mistake in wiring.
Symptoms
Possible Problems
Solutions
Motor is not rotating
No power
Connect power supply correctly
Microstep resolution setting is wrong
Setting appropriate microstep
Fault condition exists
Check wiring and restart power
