Leader Electronics Corp. LT 416, Instruction Manual, Page: 25 / 50

Figure 4-3 Key combinations to select green
(3) Interlace/Progressive Scanning Selection
The SCAN key
r
is used to select the scanning system when the CIRCLE or
CONVERGENCE pattern is selected by using the Pattern key
w
.
The key operation is toggled.
When the PROGRESSIVE is selected, the indicator lights. When the INTERLACE
is selected, the indicator goes off.
If the TV screen becomes difficult to watch due to flickering, select
PROGRESSIVE to reduce the amount of flicker.
(4) Color Burst, Reference Burst On/Off
The BURST key
t
is used to set the color burst or reference burst on or off when
the CIRCLE or CONVERGENCE pattern is selected by using the Pattern key
w
.
The key operation is toggled.
The indicator lights when the burst is set on, and vise versa.
If the TV screen becomes difficult to watch due to the coloring of the vertical line
edge, set the burst off to reduce this effect.
The BURST ⑤ key is used to set the color burst on or off when the NTSC, PAL, or NTSC
4.43 is selected by using SYSTEM key ⑨ . The BURST ⑤ key is also used to set the
reference burst on or off when the SECAM is selected by using SYSTEM key ⑨ .
4.10 RF Channel Settings
4.10.1 Setting Method
(1) About RF Output Settings
The combination of country number (COUNTRY) and channel (CHANNEL) is
used for setting the RF output frequency and RF system (i.e., modulation system,
sound subcarrier).
See 5.3 "Channel Plan Table" to select the desired RF frequency and RF system.
Note that arbitrary RF frequency and RF system cannot be set.
4-5
e
R,G,B
LED off
LED on
LED off