LEAB Clayton Power CLP 600, User Manual

Page: 9 / 13

Installation Instructions Normal Operation
Page 8 of 11
9 Normal Operation
Switching on the Device
The charging process starts automatically when a wake-up signal (pin 2) is
applied.

It is not possible to operate the device without a wake-
up signal.

If a lead-acid battery is charged, the status LED "LEAD"
illuminates green. If a lithium battery is charged, the
status LED "LITHIUM" illuminates green.
Switching off the Device
The device switches off automatically if no wake-up signal (pin 2) is applied.
10 Emergency Start Function
To activate the emergency start function, perform the following step:
A wake-up signal is applied to the device.
1. Press the “Setup” button for 3 seconds.
To end the emergency start function, perform the following step:
1. Press the “Setup” button for 3 seconds.

The starter battery is charged for a maximum of 5
minutes from the additional battery.

The status LED flashes red and green simultaneously.
The emergency start function ends, the charge booster returns to
normal operation.