To assemble the device, perform the following steps:
ü
Assemble the device on a flat and heat conductive surface.
1 Fasten the device with screws to the 4 lateral holes (Ø 4 mm).
ð
The device is assembled.
8 Installation
To install the device, perform the following steps:
1 Disconnect the starter battery from the on-board supply system.
WARNING!
Disconnect the negative cable first.
2 Secure the positive cable as close as possible to the starter battery with a
suitable fuse (60 A).
3 Connect the positive terminal of the starter battery to the DC input of the
device with a cable (25 mm
2
).
CAUTION!
First connect the charge booster and then the starter battery.
NOTE!
Loosen only the top nut.
4 Connect the negative terminal of the starter battery to the ground port
(GND) of the device with a cable (2.5 mm
2
).
ð
The device is ready for operation.
5 Connect the positive terminal of the additional battery to the DC output of
the device with a cable (25 mm
2
).
NOTE!
Loosen only the top nut.
6 Connect the negative terminal of the additional battery to the shared
ground with a cable (25 mm
2
).
7 Connect the D+ signal of the vehicle (e.g. terminal 15 or terminal 51) with the
port for the D+ signal of the device.
NOTE!
When used with lithium batteries from Clayton Power, the vehicle's D +
signal can also be transmitted via the device's CAN communication connec-
tion.
8 Connect the starter battery to the on-board supply system.
ð
The device is installed.
10
LEAB Automotive GmbH
Thorshammer 6
24866 Busdorf
LEAB Automotive GmbH
