33
USAGE
Starting up the device
Once the wine cabinet is properly installed, we advise that you clean the inside using warm water with a
low concentration of dishwashing liquid. Do not use abrasives or scouring powder; they may scratch the
surface finish.
USAGE
CAUTION! Wine cabinets are intended only for storing and preserving wine.
IMPORTANT: Your wine cabinet is ideally suitable for holding Bordeaux type bottles of 0.75 L capacity. It
can contain larger bottles; however care must be taken that they do not prevent the door from closing
properly.
-
When closing the door ensure that it does not touch any of the bottles.
-
If you load several bottles at a time, it will take longer before the cabinet reaches the desired
temperature.
-
In order to avoid damaging the door seal, ensure that the door is fully open before moving the
racks along the compartment rails.
Adjusting the temperature
Control panel for models PRO50M, PRO360M, PRO680M and PRO1320M
Control panel for models PRO560B and PRO1200B
•
Start button :
after the unit is turned on, press
for 3 seconds to turn the unit on or off
•
Button °C/°F: Press the °C/°F key to change the temperature display between Celsius and
Fahrenheit.
•
Temperature control button :
press before adjusting the temperature. When pressed once,
the display will flash and show the set temperature. After 5 seconds seconds, it shows the
measured indoor temperature. Press the
to increase the temperature setting and press
to decrease it.
For the PRO560B and PRO1200B models, each press of the
Selects the zone to be set.
- Display : LED display shows the temperature setting or the actual indoor temperature.
