Astro 250 HP 3200K and 5600K, DMX 512+ RDM LED followspot - User’s Manual – 1.0
Luci della Ribalta srl, Via Berna 14, 46042 Castel Goffredo (MN) Italy
Tel. +39 0376 771 777 – fax +39 0376 772 140 – email
– web www.ldr.it
3
•
Replacement of any part of the wiring system must be carried out exclusively by professional
personnel in compliance with the original wiring diagram and with components identical to or
compatible with those originally fitted.
•
Installation of this product must be exclusively carried out by professional personnel in
compliance with the safety norms in force in the country where the product is used.
2. CHECK PACKING CONTENT
A. Standard followspot
B. Kit followspot
Astro followspot in the chosen model
Astro f.spot in the chosen model in flight case
Separate mains power cable with PowerCon
Fitted colour-changer unit
Ø28mm spigot for followspot
Separate mains power cable with PowerCon
Iris diaphragm
Ø28mm spigot for followspot
Iris diaphragm
Black follow-spot tripod
Clamp-on mobile digital dimmer
3. MOUNTING THE SPIGOT
A spigot is supplied in standard delivery for you to tripod-mount your followspot.
•
Make sure the tripod you are going to use can withstand the product load as indicated on the
product’s label
•
Make sure the tripod you are going to use features a top aperture over 28mm dia.
•
Remove the M12 nut and the washer from the spigot.
•
Insert the spigot in the central hole of the yoke of the followspot from beneath the yoke.
•
Add the plain screw and the M12 self- locking nut and tighten the nut with a suitable tool.
•
Mount the followspot on the tripod.
4. MOUNTING THE COLOUR CHANGER (accessory, part nr. 20105106)
This section only applies in case you bought the followspot and the colour changer separately. In
case you bought a kit model the colour changer will be already fitted.
•
Mount the colour filters on the colour changer unit. See relevant instructions supplied with
the colour changer.
•
At the front of the followspot, slacken the 3 cross-head black M4 screws (two at the top
angles, one at the bottom, left-hand side angle) so that they remain inserted approximately
half-way through.
•
Position the colour changer unit on the front plate of the follow spot, making sure that the
colour levers are positioned on the left-hand side of the follow spot when viewed from the
front and hang it to the previously positioned screws.
•
Release the colour filters of the colour changer by pressing the black, flat lever in order to
have access to the screws
