PAGE 16
Status LED
The
Status LED
is used to indicate both operating modes, tuning status, and error codes. The
following table lists the LED status codes and their meaning.
LED Indication
Meaning
Status LED on.
Tuner is tuning.
Status LED goes out, then blinks once.
Tuner has completed a tuning cycle; a
good SWR match was found.
Status LED goes out, then blinks twice.
Tuning cycle is complete, tuning match is
between 1.5:1 and 3.0:1 SWR.
Status LED goes out, then blinks three
times.
Tuning cycle is complete, tuning match is
greater than 3.0:1 SWR.
Status LED blinks 4 times.
Tuning cycle failed, RF was lost in the
middle of the tune.
Status LED blinks 5 times.
Tuning cycle failed, no RF was detected.
APPLICATION INFORMATION
Mobile Operation
The AT-897P lus is perfectly suited to mobile operation. It can be installed under the
dashboard along with the transceiver, or mounted remotely. The only requirement is that the
tuner remains dry.
The supplied radio interface cable is 14 inches long. If it is desired that the AT-897P lus is
positioned farther from the transceiver than this cable length allows, a custom cable will need to
be constructed. This can be accomplished in two ways: Cut the supplied cable and solder a
jumper wire between all the connections, or purchase new connectors and cable to construct a
custom- length interface cable from scratch.
The 8-pin CAT interface connector is Kycon Connector part number KMDAX-8P, available
from available from
http://www.mouser.com
/ as Mouser part number 806-KMDAX-8P. Pinning
for this cable is one-to-one, straight through; all eight signals are used.
