LDG AT-600Pro, Operation Manual

Page: 4 / 26

PAGE 4
SPECIFICATIONS
1.0 to 600 watt power range (SSB and CW), 250W on 6M.
Silver-teflon SO-239 connectors.
Over 4,000 memories for instantaneous band changing.
Built-in 2-port antenna switch, with 2,000 memories each.
Tuning time 0.2 to 15 seconds full tune, 0.2 seconds memory tune.
1.8 to 54.0 MHz coverage. Built-in frequency sensor.
Tunes 6 to 1,000 ohm loads (16 to 150 on 6m), 6 to 4,000 ohms with optional 4:1 balun.
LED bargraph displays power level, SWR, and status.
Antenna Indicator LEDs show the currently selected antenna.
User-selectable operating parameters: Auto/Semi, 125/12.5 watt scale, and more.
Optional radio interface cables available.
Power requirements: 11 to 16 VDC @ 1A max. 7mA when idle.
Dimensions: 10.5” x 8.5” x 2.8”Weight 3 pounds.
AN IMPORTANT WORD ABOUT POWER LEVELS
The AT-600Pro is rated at 700 watts maximum power input
at most
. Many amplifiers output
well over 700 watts. Power levels that significantly exceed specifications will definitely damage
or destroy your AT-600Pro. If the tuner fails during overload, it could also damage your
transmitter, amplifier, or transceiver. Be sure to observe the specified power limitations.
IMPORTANT SAFETY WARNING
Never install antennas or transmission lines over or near power lines. You can be
seriously injured or killed if any part of the antenna, support, or transmission line touches
a power line. Always follow this antenna safety rule: The distance to the nearest power line
should be at least twice the length of the longest antenna, transmission line, or support
dimension.