PAGE 6
Back Panel
The rear panel of the AT-1000ProII has seven jacks.
•
Ant 1:
Connect a 50 ohm antenna coax feedline to this SO-239 connector. This jack is
automatically disconnected when the AT1000ProII is turned off.
•
Ant 2:
Connect a second 50 ohm antenna coax feedline to this SO-239 connector. This is the
antenna jack that is active when the
ANT 2
LED is lit on the front panel. Also, this jack is
active when the AT1000ProII is turned off.
•
Gnd (wing nut):
Connect to the antenna system ground.
•
Tx:
Connect a 50 ohm jumper coax from this jack to the ANT jack on the rear of the amplifier.
•
Ext. Meter:
Connect the LDG M1000 External Meter to this jack, or use for remote control
via PC.
•
Radio:
(optional) Connect the optional IC-PAC (Icom), Y-ACC (Yaesu), IC-2000 (Yaesu FT-
2000), or AL-PAC (Alinco) radio interface cable.
•
Power:
Connect the supplied DC coaxial power cable to this connector, and connect to a
source of 11-16 VDC @ 1A. Center pin is positive.
Summary of Contents for AT-1000PROII
Page 8: ...PAGE 8...