9
lci1.com
574-537-8900
Rev: 03.09.18
Solera
®
Destination Awning
Installation and Owner’s Manual
(For Aftermarket Application)
CCD-0001255
11�
Flip the cam lock to the roll in position. Slowly rotate the
drive head assembly clockwise to release tension.
12�
Mark the cam lock position on the roll tube.
13�
Remove the three screws holding the drive head
assembly end cap on the roll tube and set the drive head
assembly aside.
14�
Mark the roll tube grooves containing the polycords
prior to removing the fabric from the roll tube.
15�
Remove the two screws holding the fabric in place on
the roll tube.
16�
To remove the fabric, gently pull the roll tube from one
end, while another person holds the fabric in place.
Installing Replacement Fabric
1�
Unroll the replacement fabric so that the polycords are
parallel with the roll tube.
2�
Gently slide the roll tube on to the two polycords of the
fabric, making sure that the non-printed side is touching
the roll tube
(Fig.16)
.
6�
Using the three screws previously removed from the end
caps, attach the drive head and idler head assemblies to
the roll tube, making sure the orientation is the same.
NOTE:
Be sure the drive head assembly with the cam lock
is on the right-hand side of the awning.
7�
Secure the idler head and roll tube to the work bench.
8�
Rotate the drive head assembly counterclockwise the
number of turns stated on the turn chart
(Fig.18)
. Insert a
cotter pin into the end cap into the shaft on the drive head
assembly.
Fig.16
fabric
polycord in
roll tube channel
slide
FAILURE TO MAINTAIN CONTROL OF THE ROLL TUBE,
FABRIC AND DRIVE/IDLER HEADS MAY RESULT IN
INJURY OR PROPERTY DAMAGE�
Size
Turns
6
'
to 10
'
12
11
'
to 14
'
13
15
'
to 18
'
14
19
'
and up
16
Fig.18
roll
fabric
roll Tube
Fig.17
3�
Center the fabric on the roll tube.
4�
Apply the screws that were holding the polycords in
place on the roll tube.
5�
Roll the fabric onto the roll tube
(Fig.17)
. Make sure the
fabric stays snug and flat to the roll tube with the printed
side facing away.
